Fitting Dry Seals
We supply the seals. You fit them.
General guidance for the installer. The fixing method depends on the panel system and the joint, so talk to David before the first joint.
What changes on the wall
Less to carry, less to wait for.
- No masking tape on the panel faces
- No backer rod to push in
- No wet sealant bead to gun, tool or cure
- The seal arrives in its final shape and colour
We supply the seals. Your installer fits them. If you need an installer, we can recommend one.
01 Measure
Measure the joint width, W, along the run.
02 Match
Use the profile matched to that joint.
03 Fit
Fit it into the joint, as agreed with David.
Before the first joint
Measure, then call.
Five things make the call quick. The drawing at the top of the page shows what W and L mean.
- Joint width, W. Measure it in a few places along the run. Note where it varies.
- Joint runs, L. Roughly how many metres of joint, horizontal and vertical.
- The panel system. Panel type, how the edges are formed and how the panels are fixed.
- The colour. The panel colour, or the seal colour you want.
- A photo or the detail. Email it to [email protected] before the call.
Does Dry Seals fit the seals?
No. We supply the seals. Your installer fits them.
How is the seal fixed in the joint?
That depends on the panel system and the joint. David will talk you through it for your job before you start.
Can I try it before the job?
Yes. Request samples and try them on an offcut or a mock-up.
Talk the fixing through first.
Book a call with David, or get samples to try on an offcut before the job.